Solenoid Coils for use in potentially explosive environments
Nass magnet offers special components of system 8 and system 13 for use in hazardous and potentially explosive environments.
Those components have been approved in accordance to DIN EN 60079, DIN VDE 0170 and IEC 60079 by the federal physical/technical institute (PTB) conformable to the guideline 94/9/EG of the European Union.
Protection against explosions is granted when the matched components specified in the catalogue are being used.
Further details can be found in our catalog Page Catalogues
Solenoid Coil System 8 ATEX
| Width: | a) 22 and b) 30 mm |
| Connection type: | three-wired cable, with sleeve |
| Moulding material: | thermoplastic |
Solenoid Coil System 8 ATEX
| Width: | 30 mm |
| Connection type: | form A – EN 175301-803-A |
| Moulding material: | thermoset resin |
Solenoid Coil System 8 ATEX
| Width: | 30 mm |
| Connection type: | connector for cable |
| Moulding material: | thermoset resin |
Solenoid Coil System 8 ATEX with Connectors
| Width: | 30 mm |
| Connection type: | connector form A – EN 175301-803-A |
| Moulding material: | thermoplastic |
Solenoid Coil System 8 ATEX
| Width: | 36 mm |
| Connection type: | cable flexible at low temperatures, with ferrules |
| Moulding material: | thermoplastic |
Solenoid Coil System 8 CSA/FM
| Width: | 36 mm |
| Connection type: | three-wired end sleeve for strands, thread ½-NPT for cable conduit |
| Moulding material: | thermoplastic |
Solenoid Coil System 13 ATEX
| Width: | 52 mm |
| Connection type: | terminal box |
| Moulding material: | thermoplastic |
Solenoid Coil System 13 ATEX
| Width: | 36 mm |
| Connection type: | three-wired cable, with ferrules |
| Moulding material: | thermoplastic |
